Controls And Input Connections; Using The Controls And Connections; Using The Remote Control - Toshiba 42WLT58 Series Owner's Manual

Controls and input connections

A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the top of the television may be used for some functions.
RED – Power on
GREEN – Active standby
Switching on
If the RED LED is unlit check that the mains plug is connected
to the power supply. If the picture does not appear press
on the remote control, it may take a few moments.
To put the television into Standby press
control, the GREEN active standby LED will appear
(see 'Software Upgrade' section) next to the RED for a few
moments then disappear. To view the television press
again. The picture may take a few seconds to appear.

Using the remote control

Press the ATV/DTV button to select between digital
and analogue mode.
Press the MENU button on the remote control to see the
menus.
In digital mode the menu appears as a list of topics. Press
the P and Q button to highlight a topic, press OK to see
available options.
In analogue mode the menu bar at the top of the screens
will show five different topics shown in symbols. As each
symbol is selected by pressing the S or R button on the
remote control, its respective options will appear below.
i
i on the remote
i
To use the options press the P and Q button on the
remote control to move up and down through them and
OK, S or R to select the required choice. Follow the on
screen instructions. The functions of each menu are
described in detail throughout the manual.

Using the controls and connections

To alter the volume press —
To alter the programme position press
Press MENU and S , R , Q or P to control the sound
and picture options.
Press MENU twice to finish.
When connecting mono sound equipment to EXT5,
connect the audio output of the equipment to the
L/Mono socket on the television.
To select the Input, press
EXT5 as described on page 28. The television will
automatically sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone plug will mute the
sound from all speakers.
8
Standby
INPUT 5
(EXT5)
+
.
j
e e f f .
F
B until the display shows