Analogue Switch Off; Input Selection And Av Connections - Toshiba 42WLT58 Series Owner's Manual

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
B
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT4C).
An S in the display e.g.
B
input is set for an S-Video signal.
Input selection
Use the Input Selection if the television does not switch
over automatically.
Press to select
B B
1
(EXT1-5), HDMI1, HDMI2 or PC.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press
2
one of the numbered buttons.
Analogue switch-off
This is a digital television which is integrated to allow the
use of both digital and analogue services. However,
during the lifetime of this set it is very likely that
analogue services will be switched off to allow for more
new digital services.
This 'switch-off' will happen in a number of phases,
which will be advertised in your area well in advance.
It is recommended that at each phase the television is
re-tuned to ensure that existing and new digital
services can be viewed without disruption
(see Auto tuning page).
Input selection and
AV connections
3S (EXT 3S), indicates the
1, 2, 3, 4C,
B B B B
again or
B
This specifies the type of signal going into SCART 3 (EXT3)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
1
5,
2
28
INPUT signal selection
In the SET UP menu press Q until
AV connection is highlighted, then press OK.
SET UP
AV connection
Picture position
Quick Setup
Back Watch TV
MENU EXIT
With S or R select either AV or S-VIDEO as the
required input for EXT3.
AV connection
HDMI1 audio
HDMI2 audio
EXT3 input
EXT3 output
Woofer
Audio output
MENU Back EXIT Watch TV
If the colour is missing try the alternative setting.
2/2
OK
OK
OK
Auto.
Auto.
S-VIDEO
EXT1
External
Fixed