Digital Settings - Software Upgrade (Automatic Download, Searching For New Software), Common Interface - Toshiba 42WLT58 Series Owner's Manual

Digital settings – software upgrade,
Automatic download
If Automatic Download is selected the television's
software will automatically update as each version becomes
available, provided the television is in active standby.
In the Main Menu press Q to select
1
Configuration, press OK to select.
Press Q to select Receiver Upgrade, press OK
2
to select.
Press Q to select Automatic Download, then use
S or R to select Enabled or Disabled.
CONFIGURATION
Audio Language English
Subtitle Off
Favourite Mode Off
Receiver Upgrade V.1.4
Parental Settings
Automatic Download Enabled
Search for New Version
Exit
Searching for new software
If preferred, software upgrades can be searched for
manually using Search for New Version.
In the CONFIGURATION menu press Q to
1
highlight Search for New Version then press OK.
CONFIGURATION
Audio Language English
Subtitle Off
Favourite Mode Off
Software Upgrade
Receiver Upgrade V.1.4
Searching for upgrade. Please wait, or
Parental Settings
press MENU to cancel.
Search Progress:
Automatic Download Enabled
Search for New Version
Exit
The television will automatically start searching for
a software upgrade, the progress bar will move
along the line.
common interface
More
More
26
If an upgrade is found the television will
automatically start downloading, if not a screen
will appear stating that an upgrade is unavailable.
CONFIGURATION
Audio Language English
Subtitle Off
Favourite Mode Off
Software Upgrade
Receiver Upgrade V.1.4
Completed searching for upgrade.
Parental Settings
No new software was found.
Search Progress:
Automatic Download Enabled
Search for New Version
Exit
Common interface
The Common Interface Slot, situated on the back of the
television, enables the insertion of a CAM (Conditional
Access Module) and card. These are purchased from a
service provider and allow additional broadcasts to be
viewed. For information see a service provider.
Insert the CAM and card into the Common
1
Interface Slot, following the instructions provided
with the CAM. A box will appear on screen to
confirm that the CAM is loaded.
In the Main Menu press Q to select Common
2
Interface then press OK.
If two CAMs are inserted use P and Q to select
3
between the two, then press OK. Details of the
CAM should now be available.
More