Table of Contents
Advertisement
Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
POWER switch
(Full Power Down Option)
GREEN LED – On Timer set
Switching on
If the RED LED is not lit, check that the mains plug is connected
to the power supply and press the
left side of the television to switch the television on. If the
picture does not appear, press
take a few moments. The BLUE LED will be lit.
To put the television into Standby, press
control. To view the television, press
take a few seconds to appear.
For energy saving:
We recommend that you use the television with the factory
settings. The factory settings are for energy saving.
Turning the television off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all televisions. This is
recommended when the television is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy efficiency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce
energy consumption, but will still draw some power.
3D IR sensor (page 7)
Ambient Light Sensor
ORANGE LED - Programme timer set
(digital only)
RED LED – Programme timer Active
(digital only)
!
(POWER) button on the
1
on the remote control; it may
1
on the remote
1
again. The picture may
Using the remote control
Press MENU on the remote control to display the menu.
The menu appears as a list of five topics. As each symbol is
C
selected by pressing
respective options will appear below.
NOTE: The same menu is displayed in DTV (Digital TV) and
ATV (Analogue TV) modes; however, where some items are not
available in a mode, they will appear greyed out.
To use the option, press
move up and down and press
setting. Follow the on-screen instructions. The functions of
each menu are described in detail throughout the manual.
Using the controls and connections
To alter the volume gently touch –
To alter the programme position touch
2
Touch MENU and –
picture options.
Touch MENU to finish.
The Media Player feature provides access to photo, movie and
music files stored on a USB storage device that is connected via
USB 1 (USB 2 provides access to photos only).
NOTE: The USB socket has limited functionality and Toshiba can
take no responsibility for damage to other connected equipment.
To select an external input, press
source is selected.
Please always refer to the owner's manual of the equipment to
be connected for full details.
15
CONNECTING YOUR TV
USB 1 port
Media Player
USB 2 port
Photo Viewer
COMMON INTERFACE
The Common Interface is for a Conditional
Access Module (CAM).
Contact a service provider.
The software updating of CI Plus CAM
may be automatically executed. At this
time, your Recording/Reminder
programming will be canceled.
Control panel (touch sensor)
RED LED – Standby
BLUE LED – Power on
c
or
on the remote control, its
B
b
and
on the remote control to
C
c
or
to select your desired
2
+.
b p B
.
b p B
+ or
to control the sound and
o
until the appropriate input
Advertisement
Table of Contents
