Fuse; Power Cord; Light Socket - Amana ASE7000 Service Manual

Disassembly
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitors
before following any disassembly procedure.

Fuse

1. See "Component Location" Figure 3, for location.
2. Remove outer case.
3. Replace fuse and reassemble in reverse order.
NOTE: If fuse needs replaced, interlock assembly must
be replace.

Power Cord

1. Remove outer case and back panel.
2. Disconnect wiring.
3. Remove strain relief by compressing with pliers.
4. Remove power cord.
5. Reassemble power cord in reverse order.

Light Socket

1. Remove outer case.
2. Remove screws securing lamp cover bracket.
3. Unscrew light bulb from socket.
4. Disconnect wire terminals to light socket.
5. Remove screw securing light socket to light retainer.
6. Reassemble light socket in reverse order.
RS2240003 Rev. 0
!
WARNING
Replacing Oven Light Bulb
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
circuit breaker to oven before replacing light bulb.
After replacing light bulb, restore power.
To avoid personal injury or property
damage, observe the following:
• Allow oven and light bulb to cool.
• Wear gloves when replacing light bulb.
Tools Needed
• Protective gloves
• Phillips screwdriver
• 40-watt, 120-volt appliance bulb (available from
authorized distributor or servicer)
1. Remove screw from access cover on top left
wall of oven exterior. Remove access cover.
2. Remove old bulb and replace with new bulb.
3. Replace access cover and screw by reversing
procedure in step 1.
32
!
WARNING
!
CAUTION
To remove bulb,
turn in direction
shown.