Disassembly For Repair - Kenwood TK-2107 Service Manual

TK-2107
Separating the case assembly from the chassis
1. Remove the two knobs
2. Remove the two screws
3. Expand the right and left sides of the bottom of the case
assembly, Iift the chassis, and remove it from the case
assembly .
4. Taking care not to cut the speaker lead , open the chassis
and case assembly.
TK-260 :K, K2
4

DISASSEMBLY FOR REPAIR

and three round nuts .
.
Separating the chassis from the unit
1. Remove the eleven screws
2. Remove the solder from the antenna terminal using a
soldering iron then lift the unit off
3. Remove the two screws and remove the antenna
connector.
Note : When reassembling the unit in the chassis, be sure to
solder the antenna terminal.
Removing the lever
1. Raise the lever on the lower case
screwdriver into the space between the case and lever,
open the case carefully
Note : Do not force to separate the case from the lever.
Lever knob
Cace assembly
.
.
Antenna terminal
, insert a small flat
and lift the lever off.