For Husqvarna Parts Call 606-678-9623 or 606-561-4983
14
– English
CUTTING EQUIPMENT
Clean, refit and adjust.
Lift the cutting arm into position and fit
the front belt guard and belt tensioning
mechanism.
Tension the drive belt and tighten the
nuts.
www.mymowerparts.com
Clean and replace damaged or worn
parts of the belt tensioning mechanism
before fitting.
Lift the cutting arm into position. Place
the front belt guard and belt tensioning
mechanism in position.
Partially tighten the nuts.
Tension the drive belt by screwing in
the belt tensioning screw (A) until the
nut (B) is in line with the arrow (C).
Then tighten the nuts.