Cutting Equipment - Husqvarna 371K Workshop Manual Supplement

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
NOTE!
The cutting disc is driven by a drive belt that is correctly tensioned throughout its life by a powerful spring, on
condition that the belt tensioning screw is correctly adjusted.
The belt is subjected to hard, uneven loading. The pulleys also have relatively small radii, which places special
quality requirements on the belt. Always replace the belt with an original Husqvarna belt that has been thoroughly
tested to meet these special requirements.
When servicing or repairing cutting equipment it is important to visually inspect the guard for cracks and wear, and
ensure that the guard locking mechanism works in all positions.
Correct all faults as soon as you discover them to eliminate any risk of danger to the user!
10
– English

CUTTING EQUIPMENT

Removal
Models 371K, 3120K
Remove the cutting disc.
Release the tension in the belt and
remove the front belt guard and cutting
arm.
Remove the rear belt guard and drive
belt.
www.mymowerparts.com
Do as follows!
Lock the cutting disc by inserting a
suitable drift through the hole in the
cutting arm. Undo and remove the bolt,
flange washer and cutting disc.
Undo the nuts (A).
Unscrew the belt tensioning screw (B)
to release the belt tension.
Remove the front belt guard and the
cutting arm.
Remove the nuts (C) and screw (D)
(371K). Then lift off the guard and drive
belt.