Checks After Starting Engine; Cooling Water; Warming Up Engine; Manual Start And Electric Start Models - Yamaha F30B Owner's Manual

warmed up. For further information, see
page 49.
If the engine is warm and fails to start,
●
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 81.
EMU36510

Checks after starting engine

EMU36522

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
ECM01810
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
EMU27670

Warming up engine

EMU27716
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine
starts, stop the engine. Otherwise,
serious engine damage could occur.
Check the oil level and add engine oil
if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01831]
EMU36531

Checks after engine warm up

EMU36541

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36980

Stop switches

Turn the main switch to "
●
engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-
●
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
●
with the clip removed from the engine
shut-off switch.
EMU34530
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
Operation
", or press the
49