Start-Up Checks; Adjusting Trolling Speed - Yamaha F30B Owner's Manual

Instruments and indicators
even if the cooling water pressure sensor is
not installed, the cooling water pressure dis-
play can be shown by connecting an optional
sensor to the unit. For the optional sensor,
consult your Yamaha dealer. The tachome-
ter unit is available in round or square types.
Check your tachometer unit type.
1
1. Set button
2. Mode button
5
4
7
6
8
1. Tachometer
2. Trim meter
3. Multifunction display
4. Cooling water pressure
5. Cooling water/engine temperature
6. Water detection-alert indicator
7. Battery voltage
8. Oil pressure (4-stroke models)
EMU36190

Start-up checks

Place the remote control lever / gear shift le-
32
2
ZMU05415
1
2
3
ZMU05416
ver in neutral and turn the main switch to
" " (on). After all the displays come on and
the total hour display comes on, the gauge
will change to normal operation. If the buzzer
sounds and the water separator-alert indica-
tor blinks, consult your Yamaha dealer im-
mediately.
TIP:
To stop the buzzer, press the "
" " (mode) button.
EMU37690

Adjusting trolling speed

You can adjust the trolling speed randomly
by increasing or decreasing it approximately
50 r/min. When in the trolling speed setting
mode, the display switches to the normal dis-
play when the engine speed is increased
(within 3000 r/min) using the throttle. When
the throttle is closed, the display returns to
the trolling speed setting mode. For details,
see the attached operation manual.
TIP:
Trolling is affected by currents and other
●
operating conditions and may differ from
the actual engine speed.
The default engine idle speed is reset au-
●
tomatically when the display is switched to
the normal display. The default engine idle
speed is also reset automatically when the
engine is turned off or when the engine
speed exceeds 3000 r/min.
" (set) or
ZMU05931