Advertisement
MODEL SERIES 1600 ADVANTAGE SERIAL NUMBER L28563 AND ABOVE
BEFORE REMOVING OR INSTALLING ANY COMPONENT IN THE IMPINGER
OVEN BE SURE TO DISCONNECT ELECTRICAL POWER AND GAS SUPPLY
BURNER BLOWER MOTOR - REPLACEMENT
A.
Remove appropriate control box cover.
B.
Unplug motor connector.
C.
Remove three (3) screws from blower tube at burner housing.
D.
Remove air shutter assy. from old motor for installation on new motor assy.
E.
Reassemble in reverse order and check system operation.
NOTE: CHECK AIR SHUTTER ADJUSTMENT- Should be set at 1/2 open.
HOT SURFACE IGNITER - REPLACEMENT
A.
Remove appropriate control box cover.
B.
Disconnect gas line at union.
C.
Remove four (4) nuts from burner orifice bracket.
D.
Remove tube for bypass flame.
E.
Unplug connector at burner housing.
F.
Remove three (3) screws from burner housing end cap and remove
hot surface igniter and burner tube assy.
G.
Replace igniter assembly and reassemble in reverse order. CAUTION:
USE CARE NOT TO DAMAGE NEW IGNITER.
NOTE: Check all gas line fittings for leaks. Make sure connector is seated properly.
CONVEYOR DRIVE MOTOR - REPLACEMENT
A.
Shut off power at main breaker.
B.
Remove conveyor.
C.
Remove control panel top and front cover.
D.
Disconnect wiring from motor and mark for reassembly.
E.
Remove sprocket from motor drive shaft.
F.
Remove 4 screws and remove conveyor motor and mounting bracket.
G.
Remove mounting bracket from conveyor motor assembly.
I.
Reassemble in reverse order.
CAPACITOR, CONVEYOR MOTOR – REPLACEMENT
A.
Shut off power at main breaker.
B.
Remove control box cover and front panel.
C.
Discharge capacitor before removing wires. Mark wires for reassembly.
D.
Remove mounting screw and remove capacitor.
E.
Reassemble in reverse order and check system operation.
REVERSING SWITCH – REPLACEMENT
A.
Shut off power at main breaker.
B.
Remove control box cover.
C.
Disconnect wiring from reversing switch and mark for reassembly.
D.
Remove mounting nut and remove reversing switch.
E.
Reassemble in reverse order and check system operation.
Low Profile – 1600 Series Advantage Digital Service Manual – Domestic
REMOVAL, INSTALLATION & ADJUSTMENTS
(OVENS WITH PUSH BUTTON CONTROLS)
CAUTION !
9
Advertisement
