Hinge Reversal; Oven Door Hinge Reversal - Nu-Vu SUB-123P Service And Repair Manual

SUB–123P SERVICE AND REPAIR MANUAL
Tools Required:
5/16" hex key (Allen wrench)
9/16" wrench or adjustable wrench
Slotted screwdriver
Phillips screwdriver
1. Remove both side panels and access covers (on sides, level with the door switch) using a
slotted screwdriver.
2. Remove the oven door hinge bolts (4) using a 5/16" hex key.
3. With the door laying face down on a flat surface, open the inner door panel. Move the hinge
and latch pins (one at a time) (note: the pins in the long slots do not need to be moved) to the
holes next to the ones that they are in. Looking at the door from the front, the pins should be in
the upper holes.
4. Remove the screws holding the latch onto the door, flip the latch over so that the handle points
to the bottom of the door and re-install the screws.
5. Remove the door switch using a 9/16" wrench. Do not disconnect wires from the switch.
6. Remove metal plug from the door jamb opposite the door switch. If there isn't a hole opposite
the door switch, a ½" hole will need to de drilled. A center punch will be in the jamb to locate the
hole. If a hole must be drilled, remove all metal shavings afterwards.
7. Install the door switch in the ½" hole that you removed the metal plug from.
8. Install the metal plug that you removed in the old door switch hole.
9. Remove the bolts from the front face using a 9/16" wrench and install them in the holes that you
removed the hinge bolts from.
10. Remove the screw on the lath strike plate using a Phillips screwdriver. Be careful not to loose
the spacers or lock washers.
11. Install the latch strike plate on the opposite side of the front face. The screws should be
centered top to bottom in the slots.
12. Re-install the oven door using the hinges bolts that you removed in step 2 earlier.
13. The door should now be tested to insure that it seals properly. (Refer to Door Test Procedure)
®
NU-VU FOOD SERVICE SYSTEMS
5
page

OVEN DOOR HINGE REVERSAL

Important: disconnect power before beginning
Sales Fax (906) 863-5889 ♦ Service Fax (906) 863-6322
Drawing 5
OVEN DOOR REVERSAL
MENOMINEE, MICHIGAN 49858-0035
(800) 338-9886