Hitachi VT-FX614A Owner's Manual page 37

CABLE BOX SETUP - 37 -
below.
For example, press (3) (7) for the Hitachi brand cable box.
11 Press the GUIDE button to enter your cable box brand.
The VCR will change the cable box from channel 02 to channel 09 to confirm that the correct code was entered.
12 Cable box channel changed to channel 9: Press the (1) button to end this setting.
Your cable box and VCR are now set for VCR Plus+ program recording. Depending on the manufacturer and
model of the cable box, you may also be able to use the VCR remote control to:
• Change channels on the cable box with the remote's channel up/down buttons.
• Use the numbers on the VCR remote to select cable box channels directly.
Note: Only the cable box will change channels. The VCR channel will not change.
Cable box did not tune to channel 9: Press the (2) button to return to step (10), and enter a different code
number.
If the codes you entered do not work:
• Try repositioning the cable box on top of the VCR and reentering the codes.
• Try entering all code numbers (00-61). Press the number button to enter another code number.
If none of the codes work, press the GUIDE button to quit. The VCR will not control your cable box. However,
the output channel of the cable box has been set. Turn on the cable box and leave it tuned to the channel you
want to record before the recording is scheduled to begin.
Note: If you make a mistake when entering digits, press the CLEAR button repeatedly to return the white dash "-"
to the digits to be corrected. Then, punch in the correct number.