Using Mypower All Plus; Select/Connect The Adapter Tip - Tekkeon MP3750 User Manual

Using myPower ALL Plus

The main output port (DC OUT) on myPower ALL Plus can be used to power and/or charge any portable
device that requires between 10V and 19V. In general most of the devices accept a voltage tolerance up to
10%. That means this port cannot be used to power devices that require under 9V or higher than 21V. The
USB output port can be used simultaneously or separately to power and charge smaller devices requiring 5V.
To use myPower ALL Plus to power and/or charge your device, take these steps which are described in
detail in the following sections.
• Select an output adapter tip for your main device and connect the tip to the output cord.
• Connect the power output cord to myPower ALL Plus.
• Select the mode.
• Set the voltage (manual mode only).
• Connect the power output cord/output adapter tip to your laptop. See Adapters for detailed
information about adapter tips.
• To the USB port, connect a 5V device using an adapter or with the device USB cable (optional).
You also can charge your laptop and myPower ALL Plus at the same time by plugging the laptop power
adapter into myPower ALL Plus. In this case, the output current should be less than 5A to power and/or
charge your device. myPower ALL Plus will shut down and may be damaged if more than 5A is provided.

Select/Connect the Adapter Tip

1. Locate the polarity symbol on your device in the area around the power connector jack:
WARNING: myPower ALL Plus supports Center Positive polarity only. If your device has a Center Negative
polarity, do not power the device with myPower ALL Plus; contact support@tekkeon.com for assistance.
6
Center Positive
Center Negative