Connect The Portable Device; Use The Usb Port To Charge A 5V Device - Tekkeon MP3750 User Manual

Connect the Portable Device

1. Connect the output adapter tip into the power jack on the portable device (that requires between 10V
and 19V). If you have turned on the automatic detection feature in the previous step, the voltage will be
automatically detected and set for the connected device. The green LEDs will turn on/off in sequence and
stop about the voltage that has been set.
2. Turn on the portable device and use it as you would normally. While connected, myPower ALL Plus will
power (or power and charge in some cases) your device.
3. When finished, unplug the power output cord from your device and battery and slide the power switch to
OFF to turn off the battery when not in use.
TIP: For most portable devices, myPower ALL Plus can be used to power the device even when the device
battery is not installed.
WARNING: Only devices requiring between 9V and 21V (within 10% tolerance) may be connected to the
main output port. Connecting a device requiring any other voltage may damage the device.

Use the USB Port to Charge a 5V Device

You can charge a 5V device via the USB port on myPower ALL Plus. The device can be connected to
myPower ALL Plus using an adapter or the device USB cable. To preserve the battery, the USB port is
turned off as the default. If myPower ALL Plus is set to AUTO, or if myPower ALL Plus is set to MANUAL
and the Power Output Cord is connected, the USB port is on.
USER GUIDE
9