Charging With A Solar Panel - Tekkeon MP3750 User Manual

NOTE: myPower ALL Plus can be charged overnight as it will automatically shut down the power input when
fully charged.

Charging with a Solar Panel

myPower ALL Plus can be charged using a compatible solar panel. You can charge the device
using the DC IN port (5.5 x 2.1mm), or the 3-Pin Input Port.
The DC IN port is designed for use with a DC power adapter with constant current
input. Charging myPower ALL Plus requires a minimum of 1A current output from
the solar panel. In general, a 25W or higher solar panel should provide sufficient
power to charge myPower ALL Plus.
The 3-Pin Input port is designed to allow charging by smaller solar panels (lower than 25W),
and requires an optional Smart 3-Pin Adapter available from Tekkeon (see Accessories).
To use this port, there is no minimum current output requirement from the
solar panel.
1. Connect the solar panel output cable into the DC IN port
on myPower ALL Plus.
OR
Connect the 3-pin end of the optional Smart 3-PIN Adapter into
the 3-Pin Input port on the MP3750 and the other end into the
solar panel output port.
2. Verify that the red charging indicator turns on to indicate the
battery is charging and is less than 80% charged.
3. When the charging indicator turns to green, press the Capacity Display button to view the battery
capacity. If the capacity does not indicate full (all green LEDs on), continue to charge the battery until
the battery capacity indicates full.
4. When the battery capacity indicates full, unplug the connected charging cable.
USER GUIDE
LED turns on while solar panel
is charging myPower ALL Plus
5