Getting Started; Install Batteries In The Remote Control; Operating Range Of The Remote Control; Antenna Connection For Off-Air Signals - Sanyo FVM4612 Owner's Manual

Getting Started

Install Batteries in the Remote
Control
1. Open the battery cover of the remote control
by pressing down and pulling it.
2. Insert two new AAA size batteries for the
remote control. Make sure to match the
and signs on the batteries with marks
inside the remote control.
3. Close the battery cover until it clicks shut.
• Do not use rechargeables together with dry
cells, other types, mixed new and old or
batteries with different charge levels.
• Do not expose the remote control or
batteries to moisture or heat such as
sunshine.
• Please recycle used up batteries.
• Remove the batteries if the remote control
is not going to be used for an extended
period of time.
• Danger of explosion if batteries are
incorrectly replaced.
• Replace batteries only with the same or
equivalent type.
www.sanyoctv.com
Need help?
Operating Range of the Remote
Control
Point the top of the remote control toward
the TV's sensor within a distance of less than
6m/20ft, and a horizontal/vertical angle of less
than 30 degrees.
The remote control may not function properly
if the TV's sensor is under direct sunlight or
strong illumination, or when there is obstacle in
the path of signal transmission.
Antenna Connection for Off-air
Signals.
The tuner in this LCD TV can receive digital
and analog off-air signals from an antenna, or
analog or clear QAM cable channels from a
direct Cable TV connection.
NOTES:
• You must use the On-screen Menu to Search for
Clear QAM Cable channels. (see p.14)
• For the best picture, connect your Cable box or
Satellite receiver to HDMI or component jacks.
• This LCD TV can receive ANT unscrambled RF
signal being broadcasted.
1-800-877-5032
30 30
ANALOG/DIGITAL
ANTENNA IN
ANTENNA
or
CABLE
7