Troubleshooting - Zanussi ZWH 2101 User Manual

2
1
9. Close the drain pump door.
Clean the inlet valve filter
It could be necessary to clean the filter when:
• The appliance does not fill with water.
• The appliance fills with the water for a long time.
Warning! Disconnect the mains plug from the mains
socket.
To clean the filter:
• Close the water tap.
• Remove the inlet hose behind the appliance.
• Clean the filter in the valve with a stiff brush or a
towel.

Troubleshooting

The start of the appliance does not occur or it stops dur-
ing operation.
14
8. Clean the filter under
the water tap and put
it back in the pump.
Caution! Make sure
that you tighten cor-
rectly the filter to prevent
leakages.
• Install again the inlet hose. Make sure that the cou-
plings are tight to prevent leakages.
• Open the water tap.
Emergency drain
Because of a malfunction, the appliance cannot drain the
water.
If this occurs, do steps (1) through (5) of 'To clean the
drain pump'.
If necessary, clean the pump.
When you drain the water with the emergency drain proce-
dure, you must activate again the drain system:
1. Put 2 litres of water in the main wash compartment
of the detergent dispenser.
2. Start the programme to drain the water.
Frost precautions
If the appliance is installed in an area where the tempera-
ture can be less than 0 °C, remove the remaining water
from the inlet hose and the drain pump.
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a container and
let the water flow out of the hose.
5. Empty the drain pump. Refer to the emergency drain
procedure
6. When the drain pump is empty, install the inlet hose
again.
Warning! Make sure that the temperature is more
than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages caused
by low temperatures.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the service centre.
www.zanussi.com