Zanussi ZWH 2101 User Manual page 11

Using the liquid detergent
A
• Measure out the detergent and the fabric conditioner.
• Carefully close the detergent dispenser.
When you use the detergent divider:
Do not use gelatinous or thick liquid detergents.
–
– Do not put more liquid detergent than the edge of the
detergent divider.
– Do not set the prewash phase.
– Do not set the delay start function, if it is available.
Setting and starting a programme
1. Turn the programme knob and set the washing pro-
gramme.
2. The Start button indicator is off.
3. Set the available functions.
When you press the relevant button, the indicator of
the set function comes on.
4. Press the Start button to start the programme until
the button indicator is on.
Cancel a programme
1.
Turn the programme knob to
gramme and to deactivate the appliance.
2. Turn the programme knob again to activate the ap-
pliance. Now, you can set a new washing pro-
gramme.
The appliance does not drain the water.
www.zanussi.com
• Pull out the detergent
dispenser until it stops.
• Pull out the detergent
divider from its posi-
tion (A).
• Put it into the special
guides in the middle of
the compartment for the
washing phase.
to cancel the pro-
Change a function
You can change only the delay and spin function before
they operate.
Press the related button to set the new value.
Set the delay start
1. Press the delay start button again and again until to
set the correct delay.
2. Press the start button, the appliance starts the count-
down of the delay start. The related indicator flashes
while the start button indicator is off.
When the countdown is completed, the programme
starts automatically and the indicator of the start but-
ton indicator comes on.
You can cancel or change the set of the delay start
also when the appliance starts the countdown.
Cancel the delay start
Press the delay start button again and again until all the
indicators are off.
The programme starts and the start button indicator
comes on.
Open the door
While a programme operates, the appliance door is
locked.
To open the appliance door:
1.
Turn the programme knob to
appliance.
2. Wait for some minutes before to open the appliance
door.
3. Close the appliance door.
4. Set the programme again.
If the temperature and level of the water in the drum
are too high, you cannot open the door.
To open the appliance door:
• Do the steps 1 and 2 again.
• Wait for some minutes.
• Make sure that no water is in the drum.
At the end of the programme
• The appliance stops automatically.
• The start button indicator flashes or the End indicator
is on.
• Turn the programme knob to
pliance.
to deactivate the
to deactivate the ap-
11