Zanussi ZWH 2101 User Manual page 15

Warning! Deactivate the appliance before you do the
checks.
Problem
The appliance does not
start.
The appliance does not fill
with water.
The appliance does not
drain the water.
The spin phase does not
operate.
www.zanussi.com
Possible cause
The mains plug is not connected in
the mains socket.
The fuse in the box fuse is damage.
The appliance door is open.
You do not press the start button
The programme knob is not in the
correct position.
The delay start is set.
It is available only for models with
the Delay start.
The water tap is closed.
The water inlet hose is damaged.
The filter in the water inlet hose is
blocked .
The water tap is blocked or there is
limescale on it.
The connection of the water inlet
hose is not correct.
The water pressure is too low.
The water drain hose is damaged.
The filter of the drain pump is
blocked.
The connection of the water drain
hose is not correct.
A washing programme without the
drain phase is set.
The function Rinse Hold is on.
The spin phase is off.
The filter of the drain pump is
blocked.
Balance problems with the laundry
load.
Possible solution
Put in the mains plug.
Replace the fuse.
Close the door firmly.
Press the start button.
Turn the programme knob in the correct posi-
tion.
To start immediately the programme, cancel the
delay start.
Open the water tap.
Make sure that the water inlet hose has no dam-
ages.
Clean the filter. Refer to 'Care and cleaning'.
Clean the water tap.
Make sure that the connection is correct.
Contact your local water authority.
Make sure that the water drain hose has no
damages.
Clean the filter of the drain pump. Refer to 'Care
and cleaning'.
Make sure that the connection is correct.
Set the drain programme.
Set the drain programme.
Set the spin programme.
Clean the filter of the drain pump. Refer to 'Care
and cleaning'.
Adjust manually the items in the tub and start
the spin phase again.
15