Zanussi ZWH 2101 User Manual page 19

10. Put the plastic caps in the holes. You can find
these caps in the user manual bag.
Warning! Remove all the packaging and the transit
bolts before you install the appliance.
We recommend that you keep the packaging and the
transit bolts for when you move the appliance.
Positioning and levelling
• Install the appliance on a flat hard floor.
• Make sure that carpets do not stop the air circulation
below the appliance.
• Make sure that the appliance does not touch the wall
or other units
• Loosen or tighten the feet to adjust the level. A cor-
rect adjustment of the appliance level prevents the
vibration, noise and the movement of the appliance
when in operation.
• The appliance must be level and stable.
www.zanussi.com
Caution! Do not put cardboard, wood or equivalent
materials below the appliance feet to adjust the
level.
The inlet hose
• Connect the hose to the appliance. Loose the ring
nut to set it in the correct position.
x4
Caution! Make sure that there are no leaks from the
couplings.
x4
Do not use an extension hose if the inlet hose is too
short. Contact the service centre for the replacement
of the inlet hose.
Water drainage
There are different procedures to connect the drain hose:
With the plastic hose guide
• Connect the water inlet
hose to the cold water
tap with 3/4 thread.
19