Jlan1/2 Enable/Disable; Vga Enable/Disable; I C To Pci Enable/Disable; Sata Controller Enable/Disable - Supermicro Supero H8DAR-T User Manual

H8DAR-T/H8DAR-E User's Manual

JLAN1/2 Enable/Disable

Change the setting of jumper JPL
to enable or disable the JLAN1 and
JLAN2 Gb Ethernet ports. See the
table on the right for jumper settings.
The default setting is enabled

VGA Enable/Disable

JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
I 2 C to PCI Enable/Disable
JI 2 C1/2 pair of jumpers allow you to
connect the System Management Bus
to any one of the PCI slots. The default
setting is on pins 1-2 for both jumpers
to enable the connection. Both con-
nectors must have the same setting
2
(JI C1 is for data and JI
clock). See the table on right for jump-
er settings.
SATA Controller Enable/
Disable (H8DAR-T)
Jumper JPS1 is used to enable or dis-
able the Marvell 88SX6081 Serial ATA
controller. The default setting is on pins
1-2 to enable SATA. See the table on
right for jumper settings.
2
C2 is for the
2-16
JLAN1/2 Enable/Disable
Jumper Settings (JPL)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
I 2 C to PCI Enable/Disable
Jumper Settings
2
(JI C1/2)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SATA Enable/Disable
Jumper Settings (JPS1)
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled