H8QM8-2+/H8QME-2+ User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
JLAN Enable/Disable
Change the setting of jumper JPL1
to enable or disable the JLAN1 and
JLAN2 Gb Ethernet ports. See the
table on the right for jumper settings.
The default setting is enabled.
SCSI Controller Enable/
Disable (H8QM8-2+ only)
Jumper JPA1 is used to enable or dis-
able the Adaptec AIC-7902W SCSI
controller. The default setting is on pins
1-2 to enable SCSI. See the table on
right for jumper settings.
SCSI Termination Enable/
Disable (H8QM8-2+ only)
Jumpers JPA2 and JPA3 are used to
enable or disable termination for SCSI
channels A and B, respectively. The
default setting is open to enable termi-
nation. See the table on right for jump-
er settings.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
JLAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting
Pins 1-2
Pins 2-3
SCSI Enable/Disable
Jumper Settings (JPA1)
Both Jumpers
Pins 1-2
Pins 2-3
SCSI Term. Enable/Disable
Jumper Settings (JPA2/JPA3)
Jumper Setting
Open
Closed
2-16
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled