Paper End Setting For Feed Gap Sensor - TEC B-880 series User Manual

6. DIAG. TEST OPERATION

6.5.5 Paper End Setting for Feed Gap Sensor

Paper end setting should be performed after replacing the CPU PC board or changing the label
to other maker's one, or when a paper feed error occurs.
Press the [FEED] key
and [RESTART] key
at the same time.
NOTE: Pressing the [PAUSE] key validates the sensor adjustment. The value of the sensor is
displayed up to 5.0 V.
Power off
Turn on the power while holding down
the [FEED] key and [PAUSE] key.
< 1 > D I A G N O S T I C
Press the [FEED] key three times.
< 4 > S E N S O R
Press the [PAUSE] key five times.
[ P E L E V E L . T ]
Remove any paper from
the sensor detecting area.
Holding the [FEED] key or [RESTART]
key down until an asterisk ( * ) is
displayed. (More than 3 seconds.)
Ex)
[ P E L E V E L . T ]
Press the [PAUSE] (See NOTE.)
V 1 . 0 A
A D J U S T M E N T
4 . 8 V
4 . 8 V *
6-66
EO18-33007
6.5 SENSOR SETTING MODE
The former value is displayed.
Indicates the completion of
adjustment .