Self Test - TC Electronic INTONATOR User Manual

APPENDIX -
PRESS AND HOLD THE "CORRECTION BYPASS" KEY,
WHILE POWERING UP, TO ACCESS THE SELF TEST
Use the ALPHA dial knob to select a test, and push the knob to
activate or deactivate a test. The self tests are described below.
Key test
Test the keys one by one.
Push the ALPHA dial knob to start the test.
Push the keys one by one.
ALPHA DIAL test
Test the clicks on the ALPHA dial.
Push the ALPHA DIAL knob to start the test.
Turn the APLHA DIAL knob 15 clicks clock wise, then 15 clicks
counter-clockwise.
Display test
Push the ALPHA dial knob to start the test.
All pixels on the display must be lit.
Push the ALPHA DIAL knob to stop the test.
LED test
Push the ALPHA dial knob to start the test.
All LEDs must be lit.
Calibrate pots
This test is used for calibration of the potentiometers.
Start the calibration by pushing the ALPHA dial knob.
All pots must be set in the middle position. If any of the pots are
outside the specified range, the LED close to the potentiometer
will flash. If the pots are OK the setting will be stored when
pushing the ALPHA dial knob.
Analog I/O test
Connect a balanced cable from one of the analog Outputs of the
Intonator directly to one of the analog Inputs on the Intonator.
Push the ALPHA dial knob to start the test.
The display will show whether the Input/Output is OK or NOT
OK. If NOT OK, try to the test with the other analog
Input/Output to narrow down the problem.
The Signal LED is lit to show signal at the Input.
28

Self test

AES/EBU I/O test
Connect a balanced cable from the Intonator AES/EBU Input
directly to the Intonator AES/EBU Output. Push the ALPHA dial
knob to start the test. The display will show whether the
Input/Output is OK or NOT OK.
The Signal and Peak LEDs are lit to show signal at the Input.
S/PDIF I/O test
Connect a RCA cable from the Intonator S/PDIF Input directly to
the Intonator S/PDIF Output. Push the ALPHA dial knob to start
the test. The display will show whether the Input/Output is OK or
NOT OK.
The Signal and Peak LEDs are lit to show signal at the Input.
Opto I/O test
Connect an optical cable from the Intonators OPTO Input
directly to the Intonator OPTO Output
Push the ALPHA dial knob to start the test.
The display will show whether the Input/Output is OK or NOT
OK. The Signal and Peak LEDs are lit to show signal at the Input.
MIDI In/Out test
Connect a standard MIDI cable between MIDI IN and OUT.
Push the ALPHA dial knob to start the test.
The display will show whether the Input/Output is OK or NOT OK.
External Control In test
Connect a jack plug to the External Control In.
Push the ALPHA dial knob to start the test.
When the tip of the jack plug is connected to ground, the display
must read OK.
Battery test
Push the ALPHA dial knob to start the test.
If not OK; contact your dealer.
System test
Push the ALPHA DIAL knob to start the test.
The system test will check the DARC, DSP, DSP RAM, EX
RAM and EEPROM to some extend.
If not OK; contact your dealer.
Power Off - On to start the Operating System software.
Service note:
In case of the unlikely event that the unit needs to be sent in for
service, please pack the unit in the original box AND an outer
box before sending it.