Power On/Off; Turning On The Power; Turning Off The Power - Hitachi CP-X1230 User Manual – Operating Manual

Power ON/OFF

Power ON/OFF
WARNING • When the power is ON, a strong light is emitted. Do not look
into the lens or vents of the projector.
NOTE
• Turn the power on/off in right order. Please power on the projector before
the connected devices. Power off the projector after the connected devices.

Turning On The Power

1
Remove the lens cap.
Set the power switch to [ | ] (ON).
2
The STANDBY/ON indicator will light to
solid orange.
Press the STANDBY/ON button.
3
The projector lamp will light up and the
STANDBY/ON indicator will begin blinking
green.
When the power is completely on, the
indicator will stop blinking and light green.
Select an input signal according to the
4
section "Selecting An Input Signal" of the
following page.

Turning Off The Power

Press the STANDBY/ON button.
1
The message "Power off?" will appear on
the screen for approximately 5 seconds.
Press the STANDBY/ON button again while
2
"Power off?" the message is visible.
The projector lamp will go off, and the
STANDBY/ON indicator will begin blanking orange.
Then the STANDBY/ON indicator will stop blinking
and light to solid orange when the lamp cooling is
complete.
Switch the power switch to [O] (OFF).
3
The STANDBY/ON indicator will go off.
Attached the lens cap.
4
14
STANDBY/ON button /
STANDBY/ON
indicator
Power switch (ON position)
STANDBY/ON button /
STANDBY/ON
indicator
Power switch (OFF position)
SEARCH
VIDEO RGB
ASPECT PinP AUTO BLANK
MAGNIFY
VOLUME
STANDBY/ON
button
VIDEO RGB SEARCH
BLANK
ASPECT PinP AUTO
MAGNIFY
VOLUME
STANDBY/ON
button