Table of Contents
Advertisement
Lamp (continued)
Lamp (continued)
Replacing The Lamp
If the indicators or a message prompts you to replace the lamp, replace the lamp as soon
as possible.
Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at
1
least 45 minutes.
Contact your dealer to prepare a new lamp. Tell the dealer your lamp type number.
2
If the projector is mounted on the ceiling, or if the lamp has broken, also ask the
dealer to replace the lamp.
In the case of replacement by yourself,
After making sure that the projector has cooled
3
adequately, slide the knob of a lamp cover lock as
shown in the Figure. Then, one side of the lamp
cover is raised. Pull up the lamp cover and remove
it, as shown in the Figure.
Unscrew the 3 screws, and slowly pull out the lamp
4
by the handle. Be careful not to touch the inside of
the lamp case.
Insert the new lamp, and tighten the 3 screws firmly
5
to lock it in place.
Interlocking the 2 tabs of the lamp cover to the
6
projector, put the lamp cover on the projector. Then
push the point of the lamp cover to fix it, as shown in
the Figure. Make sure that the lamp cover does't
come up.
Turn on the projector, and reset the lamp timer.
7
(1) While the projector running, press the MENU button to open the menu.
(2) Choose the "OPTION" on the menu using the
button or ENTER button.
(3) Choose the "LAMP TIME" using the
RESET button for 3 seconds.
(4) Choose the "RESET" using the
When the lamp has been replaced after the message of "THE POWER WILL
memo
TURN OFF AFTER 0hr." is displayed, complete this operation within 10 minutes of
switching power on.
Incorrectly resetting of the lamp timer (resetting without replacement, or
memo
neglect of resetting after replacement) will result in incorrect message functions.
Lamp cover
knob
Screws
/
button, then press and hold the
/
button.
Lamp cover
Tabs
button, then press the
35
Advertisement
Table of Contents
