Back to Contents Page
Display Assembly
Dell™ Latitude™ X1 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Assembly
CAUTION:
Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
You must remove the display assembly before you remove the palm rest.
1. Follow the instructions in
"Preparing to Work Inside the
2. Remove the keyboard.
3. Remove the
hinge
covers.
4. Close the display and turn the computer upside down.
5. Remove the two screws labeled "D" from the bottom of the computer.
6. Turn the computer top-side up and open the display.
7. Remove the two M2 x 5.5-mm screws from the hinges.
8. Remove the captive display-cable ground screw (if present).
9. Disconnect the display cable using the pull-tab, and release the cable from the cable-routing guides.
10. Disconnect the two antenna-cable connectors.
11. Lift the display straight out of the computer base.
Computer."