Set Up the Hardware
1. Start the system, then connect the external source signal to the House
Sync connector (BNC) of the Quadro G-Sync II option card.
The Quadro G-Sync II supports the following
external synchronization signal types:
TTL (3.3 volt level)
Composite Bi-level (NTSC or PAL sources
use bi-level composite signals)
Composite Tri-level (HDTV sources commonly
use tri-level composite signals)
2. Check the LED on the connector panel.
A green LED means the hardware has detected the
timing signal, and you can proceed to the next step
An occasional red fl ash is OK.
A red LED means the hardware can't detect the timing signal.
Check the signal source and correct the
problem before proceeding.
Sync Source
NVIDIA Frame Synchronization Under Linux
NVIDIA Quadro G-Sync II
Connector Bracket
Server
29