Set Up The Hardware - Nvidia QUADRO G-SYNC II User Manual

Set Up the Hardware

1. Daisy chain the graphics cards together using a standard CAT5
patch cable plugged into the external RJ45 connector.

You can connect to any of the two RJ45 connectors
located on the G-Sync II bracket.

Each connector automatically confi gures itself as an input or
output after all the connections are made and one system is
confi gured as a synchronization server (see Set Up the Server
Software on page 18). A fl ashing green LED indicates an input
and a fl ashing yellow LED indicates an output.
If there is no server assigned and connected,
then both LEDs are a steady green.
Note:
WARNING! The voltage and signal on the frame lock
ports are different from Ethernet signals. Do not connect
a Frame lock port to an Ethernet card or network
hub. Doing so can cause damage to the hardware.
2. Designate one of the cards to be the server device. The remaining
cards are client devices.
The server determines the trigger pulse for the client devices. The
trigger pulse is derived from the v-sync of the server video.
In
Client
NVIDIA Frame Synchronization Under Windows
Out Out
Out In
Client
Server
In
Client
17