Download Print this page
Traynor YBA300 Manual

Traynor YBA300 Manual

All-tube bass guitar amplifier
Hide thumbs Also See for YBA300:

Advertisement

Available languages

Available languages

Quick Links

Y B A 3 0 0
A L L - T U B E
B A S S
G U I T A R
A M P L I F I E R
MODEL TYPE: YS1087

Advertisement

loading

Summary of Contents for Traynor YBA300

  • Page 1 Y B A 3 0 0 A L L - T U B E B A S S G U I T A R A M P L I F I E R MODEL TYPE: YS1087...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS This lightning flash with arrowhead symbol, within The exclamation point within an equilatereal triangle is an equilateral triangle, is intended to alert the user to intended to alert the user to the presence of important the presence of uninsulated “dangerous voltage” operating and maintenance (servicing) instructions in within the product’s enclosure that may be of sufficient the literature accompanying the appliance.
  • Page 3 Take some time to read this manual and learn about the unique features which this amplifier has to offer. We wish you and your YBA300 many years of happy gigging together. Features • Three 12AX7 pre-amp tubes, a 12AU7 Driver, and twelve 6L6/EL34 power output tubes making 300 Watts of all tube power and tone.
  • Page 4 3. Deep Switch The YBA300 is equipped with a Deep switch to help accentuate deep bass and treble frequencies. 4. Bright Switch The Bright switch provides a small amount of treble boost for added presence. The effect is more pronounced at lower gain settings.
  • Page 5 Extension speaker cabinets are connected using the Speaker ¼-inch output jacks or the “Speakon” connector. Connections to these jacks are in parallel. Using the Speaker Load switch, the output of the YBA300 can be optimized to provide the rated full power (300 watts) for selected loads (4-ohms or 2-ohms).
  • Page 6 The power tubes are accessible through either the top or the back grille. The pre-amp tubes are accessible through the grille on the bottom of the YBA300. A Phillips screwdriver is all that is needed to remove any of the grilles.
  • Page 7 Bias Bias Bias Bias Bias NOTE: All ‘Protect’ and ‘Low’ LEDs are illuminated when the unit is in standby mode. TRAYNOR YBA300 THIS UNIT MUST BE GROUNDED! DISCONNECT POWER WHEN REPLACING TUBES. Effects Loop D.I. EQ Ground Tuner CET APPAREIL DOIT ETRE MIS Á TERRE!
  • Page 8: Caractéristiques

    • Prises d’envoi et de retour d’effets (Sortie Pré-Ampli et Entrée Ampli de Puissance). Ces prises assurent un accès direct à la chaîne de signal de YBA300 vous permettant d’acheminer le signal à un autre amplificateur ou d’acheminer le signal d’un amplificateur externe au YBA300.
  • Page 9 Active 2. Prises d’entrées Passive 0dB et Active -6dB Le YBA300 est équipé de deux prises d’entrées. L’entrée passive de 0 dB alimente directement le premier étage d’entrée du premier tube alors que l’entrée –6 dB applique une atténuation au signal. L’entrée –6 dB est généralement utilisée pour les guitares basses équipées de micros actifs, ou qui ont un niveau de sortie particulièrement élevé.
  • Page 10 La prise d’envoi aux effets (sortie Préamplificateur) peut être utilisée pour acheminer le signal à un autre YBA300 ou comme envoi pour effet externe. La prise de retour d’effet (entrée d’Amplificateur de puissance) amène le signal directement à...
  • Page 11: Sp Ea K Er Ou T Put

    Bias 13. Sélection de Lampe de Remplacement & Polarisation Votre YBA300 est fournit avec un ensemble de lampe de sortie appariés à l’usine. Quand viendra le temps de remplacer les lampes de sortie, remplacez les avec un ensemble apparié afin de préserver le haut niveau de performance de votre amplificateur. Il est seulement nécessaire que les paires individuelles correspondent les unes aux autres.
  • Page 12 Bias Bias Bias Bias Bias NOTE: All ‘Protect’ and ‘Low’ LEDs are illuminated when the unit is in standby mode. TRAYNOR YBA300 THIS UNIT MUST BE GROUNDED! DISCONNECT POWER WHEN REPLACING TUBES. Effects Loop D.I. EQ Ground Tuner CET APPAREIL DOIT ETRE MIS Á TERRE!
  • Page 13 Specifications All Tube Bass Head Type 300 @ 2/4 ohms switchable Power @ min. impedance (Watts) Minimum Impedance (ohms) 400 Watts Burst Power - 2 cycle 30 - 16,000 Frequency Response (Hz +/-3dB) -90db Hum and Noise (dB) Input Channels 2 x 1/4inch Channel 1 - inputs Gain...
  • Page 15 Yorkville Sound or your dealer. If this product should fail for any reason within two years of the original purchase date, simply return it to your Traynor dealer with original proof of purchase and it will be repaired free of charge.
  • Page 16 CANADA U.S.A. Yorkville Sound Yorkville Sound Inc. 550 Granite Court 4625 Witmer Industrial Estate Pickering, Ontario Niagara Falls, New York L1W-3Y8 CANADA 14305 USA Voice: (905) 837-8481 Voice: (716) 297-2920 Fax: (905) 837-8746 Fax: (716) 297-3689 Manual-Owners-YBA300-00-1v2 • Aug. 29/2011...

This manual is also suitable for:

Ys1087