Supermicro H8DGi User Manual page 40

H8DG6/i(-F) SERVERBOARD USER'S MANUAL
LAN Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the LAN1/2 Ethernet
ports. See the table on the right for
jumper settings. The default setting
is enabled.
SAS Enable/Disable
J P S1 a l l o w s yo u t o e n a b l e o r
disable the SAS controller on the
H8DG6/H8DG6-F serverboards. The
default position is on pins 1 and 2 to
enable SAS. See the table on the right
for jumper settings.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
I2C to PCI-Express Slot
JI2C1/JI2C2 allows you to enable the
2
I C bus to communicate with the PCI-
Express slot. For the jumpers to work
properly, please set both jumpers to
the same setting. If enabled, both
jumpers must be enabled. If disabled,
both jumpers must be disabled. See
the table on the right for jumper
settings.
LAN Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Setting
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
2
I C to PCI-Express Slot
Jumper Settings
(JI2C1/JI2C2)
Jumper Setting
Closed
Open
2-20
(JPL1)
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled