Mounting A New Wheel; Removing A Wheel - Mercedes-Benz GL Operator's Manual

Example
Make sure the foot of the jack is directly
X
beneath the jacking point.
Turn ratchet wrench ? until jack = sits
X
completely on jacking point ; and the
base of the jack lies evenly on the ground.
Turn ratchet wrench ? until the tire is
X
raised a maximum of 1.2 in (3 cm) from the
ground.

Removing a wheel

! Do not place wheel bolts in sand or on a
dirty surface. The bolt and wheel hub
threads could otherwise be damaged when
you screw them in.
Unscrew the uppermost wheel bolt
X
completely.
Screw alignment bolt : into the thread
X
instead of the wheel bolt.
Unscrew the remaining wheel bolts fully.
X
Remove the wheel.
X
Changing a wheel

Mounting a new wheel

G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event
of damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
G
WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is a risk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
! To prevent damage to the paintwork, hold
the wheel securely against the wheel hub
while screwing in the first wheel bolt.
Always pay attention to the instructions and
safety notes in the "Changing a wheel"
section ( page 427).
Y
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety
reasons, Mercedes-Benz recommends that
you only use wheel bolts which have been
approved for Mercedes-Benz vehicles and the
respective wheel.
! Always use wheel bolts ; to mount the
"Minispare" emergency spare wheel. Using
other wheel bolts to mount the "Minispare"
emergency spare wheel could damage the
brake system.
431
Z