Blind Spot Assist - Mercedes-Benz GL Operator's Manual

Problems with Night View Assist Plus
Problem
The picture quality of
Night View Assist Plus
has deteriorated.
Lane Tracking package
General notes
The Lane Tracking package consists of Blind
Spot Assist ( page 243) and Lane Keeping
Y
Assist ( page 245).
Y

Blind Spot Assist

General notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from a speed of
approximately 20 mph (30 km/h). A warning
display in the exterior mirrors draws your
attention to vehicles detected in the
monitored area. If you then switch on the
corresponding turn signal to change lanes,
you will also receive a visual and audible
collision warning. Blind Spot Assist uses
sensors in the rear bumper for monitoring
purposes.
Possible causes/consequences and M M Solutions
The windshield wipers are smearing the windshield.
Replace the wiper blades (
X
The windshield is smeared after the vehicle has been cleaned in a
car wash.
Clean the windshield (
X
There is windshield chip damage in the camera's field of vision.
Replace the windshield.
X
The windshield is fogged up on the inside.
Defrost the windshield (
X
The windshield is iced up.
De-ice the windshield (
X
There is dirt on the inside of the windshield.
Clean the inside of the windshield (
X
Driving systems
page 141).
Y
page 379).
Y
page 160).
Y
page 159).
Y
page 379).
Y
Important safety notes
G
WARNING
Blind Spot Assist does not react to:
vehicles overtaken too closely on the side,
R
placing them in the blind spot area
vehicles which approach with a large speed
R
differential and overtake your vehicle
As a result, Blind Spot Assist may not give
warnings in such situations. There is a risk of
an accident.
Always observe the traffic conditions
carefully, and maintain a safe lateral distance.
Blind Spot Assist is only an aid. It may fail to
detect some vehicles and is no substitute for
attentive driving.
i
USA only:
This device has been approved by the FCC
as a "Vehicular Radar System". The radar
sensor is intended for use in an automotive
radar system only. Removing, tampering
with, or altering the device will void any
243
Z