Figure 6-39: Allowed Ip - Ip Range - Cisco Linksys AG310 User Manual

ADSL2+ Gateway with VoIP
Use https. This checkbox enables HTTPS (HyperText Transport Protocol Secure) - An extension to the standard
HTTP protocol that provides confidentiality by encrypting the traffic from the website. By default this protocol
uses TCP port 443.
Remote Upgrade
Remote Upgrade. This feature allows the Gateway's firmware to be upgraded remotely by a TFTP server. To
enable Remote Upgrade, click Enable.
SNMP
SNMP is a popular network monitoring and management protocol. To enable SNMP, click Enabled. To disable
SNMP, click Disabled.

Figure 6-39: Allowed IP - IP Range

If enabled, then specify the IP address(es) allowed to have SNMP access. Select All to allow all IP addresses
with no restrictions, IP address to specify a single IP address, or IP range to specify a range of IP addresses.
Device Name. Enter the name of the Gateway.
SNMPv1/v2c
Get Community. Enter the password that allows read-only access to the Gateway's SNMP information.
Set Community. Enter the password that allows read/write access to the Gateway's SNMP information.
SNMPv3 Security
SNMPv3. Click Enable if you wish to manage the Gateway using SNMP version 3.
R/W User. Enter a name for the user who will have read/write access to the Gateway's settings. The default name
is v3rwuser.
Auth-Protocol and Auth-Password (Authentication protocol and password). Select an authentication protocol
and enter a password. It is recommended that the password be at least eight characters long.
Priv-Protocol and Priv-Password (Privacy protocol and password). To enable encryption of SNMP version 3
communications, select CBC-DES and enter a password. If encryption is not desired, select None.
Trap Management
Trap to. Enter the IP address of the computer that will receive trap messages.
Chapter 6: Configuring the ADSL2+ Gateway 45
The Administration - Management Tab