Table of Contents
Advertisement
M S-92A2 Server
Chipset
USB Functions
This setting specifies the USB function.
USB 2.0 Controller
Set to [Enabled] if you need to use any USB 2.0 device in the operating system that
does not support or have any USB 2.0 driver installed, such as DOS and SCO Unix.
82566 / 82575 LAN Boot
Use these settings to enable/disable Remote Network Boot via PXE.
82566 / 82575 Wake Up From S5
Use these settings to specify whether the system will be awakened from power
saving modes when activity or input signal of onboard LAN is detected.
PWRON LAN1&2 / LAN3&4 Bypass Control, PWROFF LAN1&2 / LAN3&4
Bypass Control
LAN bypass feature removes a single point of failure so that essential business
communication can continue while a network failure is diagnosed and resolved. In
the event of a power, hardware or software failure, Hardware Bypass will automati-
cally activate, allowing network traffic to continue. Traffic between the LAN and
W AN is allowed without interruption. Use these settings to determine the power-on
& power-off LAN bypass mode.
3-20
Advertisement
Table of Contents
