MSI P1-109N-L70 User Manual page 63

Console Redirection
Remote Access
The setting enables/disables the remote access function. W hen set to [Enabled],
us ers may c onfigure the f ollowing s ettings f or remote ac cess type and
parameters.
Serial Port Number, Base Address, IRQ, Serial Port M ode
Use these settings to configure ports for remote access.
Flow Control
Flow control is the process of managing the rate of data transmission between
two nodes. It's the process of adjusting the flow of data from one device to
another to ensure that the receiving device can handle all of the incoming data.
This is particularly important where the sending device is capable of sending
data much faster than the receiving device can receive it.
Redirection After BIOS POST
This setting determines whether or not to keep terminals' console redirection
running after the BIOS POST has booted.
Terminal Type
To operate the system's console redirection, you need a terminal supporting
ANSI terminal protocol and a RS-232 null modem cable connected between the
host system and terminal(s). This setting specifies the type of terminal device
for console redirection.
VT-UTF8 Combo Key Support
This setting enables/disables the VT-UTF8 combination key support for ANSI/
VT100 terminals.
BIOS Setup
3-13