Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE
If you have followed the instructions contained in this manual and have difficulty in operating
your VCR, locate the PROBLEM in the left column below. Check the corresponding
CORRECTIVE ACTION columns to remedy the problem.
PROBLEM
No power.
Timer recording is not possible.
Cannot go into Record mode.
Playback picture is partially noisy • Adjust tracking control for a better picture by using
No picture but the audio is OK in
playback.
No picture or poor picture on
playback.
On-the-air TV program cannot be
seen.
No operation from the infrared
Remote Control
Video or color fades in and out
when making a copy of a video
tape
CORRECTIVE ACTION
• Make sure the AC cord is connected to an AC outlet
• Make sure the power is turned on.
• Make sure the timer recording is set correctly.
• Make sure the power is off.
• Make sure the VCR clock is set correctly.
• Make sure the tape has an erase-prevention tab. If
the hole with plastic tape.
the CHANNEL
• Head cleaning may be necessary. Refer to "HEAD
CLEANING" on
• Set your TV to the VCR mode and/or press the
VCR/TV button on the remote control so that the
"VCR" indicator on the display comes on.
• Fine tune your TV.
• Re-check the ANT. IN and ANT.OUT connections.
• Set your TV to the TV mode and/or press the
VCR/TV button on the remote control so that the
"VCR" indicator on the display disappears..
• Make sure the AC cord is connected to an AC
• Check batteries in remote control
• None. (You are copying a copyrighted tape and are
experiencing copy guard protection.)
needed, cover
or
button on the VCR.
page 34.
See page 10.
outlet.
64
Advertisement
Table of Contents
