Optional Blower Kit; Optional Rear Vent Shield; Optional Bottom Heat Shield - Harman Oakleaf Wood Stove Owner's Manual

Oakleaf Woodburning Stove
D. Optional Blower Installation
The optional blower kit #1-00-797032 installs easily to the
rear of the Oakleaf.
Hold the blower assembly into place and secure it with the
two bolts provided. You'll need a 3/8" wrench or socket to
tighten the bolts.
Secure blower with one bolt on each end of the mounting plate.
Notice: when installing the optional blower, the upper rear
shield must be moved upward to create the air passage.
Loosen the eight screws to remove the rear shield. Raise the
shield to the upper set of holes, re-install the shield, and tighten
the screws.
!
ROUTE POwER CORD AwAY FROM THE APPLIANCE.
DO NOT RUN THE CORD UNDER OR IN FRONT OF
THE APPLIANCE.
Plug the blower into a properly grounded electrical outlet.
You can turn the blower on at any time using the rocker
switch on the rear of the blower housing. Setting the switch
to "AUTO" will keep the blower off until there is a significant
amount of heat from the stove. In this setting, the blower will
also shut off when the stove cools. Keep the blower on low
speed or off during low fires. As you get out of the low burn
range, the speed can be set wherever desired, or kept off.
3-90-798
WARNING
Harman® • Oakleaf Owner's Manual_R11 • 2013 -___ • 09/13
E. Optional Rear-vent Rear Shield
Whenever a rear vent configuration is used, the upper
rear heat shield, #1-00-797066 must be purchased and
installed, to accommodate the flue collar. There are eight
screws that secure the existing shield. You'll need to break
away the tabbed portion of the lower shield flue cut-out.
Remove the screws from the top-vent shield and install the
rear vent shield in it's place. Height adjustment for blower
use is done the same as with the top-vent shield in place.
See D. Optional Blower Installation (above) for detailed
instructions.
F. Optional Bottom Heat Shield
Part #1-00-797058 must be purchased and installed
whenever the Oakleaf is installed on a protected combustible
floor. The shield installs on four bolts that are protruding
downward from the base of the stove body. Slide the shield
under the stove from the back, as this is the only way it will
fit. Lift into place guiding the bolts through the holes in the
shield and secure with the nuts that are included with the
shield.
If not installing the
optional blower, the
upper knockout will
need to be removed.
Shown with lower
shield knockout
removed.
Dry Seasoned Wood Only! 23