D-Link AirPlus DI-614+ User Manual page 23

difficulties working through NAT (Network Address Translation). Special
Applications makes some of these applications work with the DI-614+. If you
need to run applications that require multiple connections, specify the port
normally associated with an application in the "Trigger Port" field, select the
protocol type as TCP or UDP, then enter the public ports associated with the
trigger port to open them for inbound traffic.
The DI-614+ provides some predefined applications in the table on the
bottom of the web page. Select the application you want to use and enable it.
Note! Only one PC can use each Special Application tunnel.
Trigger Name: This is the name referencing the special application.
Trigger Port: This is the port used to trigger the application. It can be either
a single port or a range of ports.
Trigger Type: This is the protocol used to trigger the special application.
Public Port: This is the port number on the WAN side that will be used to
access the application. You may define a single port or a range of ports. You
can use a comma to add multiple ports or port ranges.
Public Type: This is the protocol used for the special application.
Schedule: This is the schedule of time when the special application will be
enabled.
ADVANCED > FILTERS
Filters
Filters are used to deny or
allow LAN (Local Area
Network) computers from
accessing the Internet.
The DI-614+ can be setup
to deny internal computers
by their IP or MAC
addresses. The DI-614+
can also block users from
accessing restricted web
sites.
IP Filters
Use IP Filters to deny LAN
IP addresses from
accessing the Internet.
You can deny specific port
numbers or all ports for