Troubleshooting - D-Link AirPlus DI-614+ User Manual

6.

Troubleshooting

This chapter provides solutions to problems that can occur during the
installation and operation of the DI-614+ Wireless Access Point. We cover
various aspects of the network setup, including the network adapters.
Please read the following if you are having problems.
(Note: It is recommended that you use an Ethernet connection to
1. The computer used to configure the DI-614+ cannot access the
Configuration menu.
•
•
•
Note: The IP Address of the DI-614+ is 192.168.0.1. All the computers on the
network must have a unique IP Address in the same range, e.g., 192.168.0.x.
and a Subnet Mask of 255.255.255.0. Any computers that have identical IP
Addresses will not be visible on the network.
•
configure the DI-614+ Access Point.)
Check that the Ethernet LED on the DI-614+ is ON. If the
LED is not ON, check that the cable for the Ethernet
connection is securely inserted.
Check that the Ethernet Adapter is working properly. Please
see item 6 (Check that the drivers for the network
adapters are installed properly) in this Troubleshooting
section to check that the drivers are loaded properly.
Check that the IP Address is in the same range and subnet
as the DI-614+. Please see Checking the IP Address in
Windows XP in the Networking Basics section of this
manual.
Do a Ping test to make sure that the DI-614+ is responding.
Go to Start>Run>Type Command>Type ping 192.168.0.1.
A successful ping will show four replies.