Table of Contents
Advertisement
Adjusting the stereoscopic effect –
You can select a monitoring method when adjusting the stereoscopic effect of a 3D image. In addition to
ordinary 3D representation, anaglyph (the left and right images are colored differently) and LR sequential (the
left and right images are displayed alternately) are available for monitoring and adjusting parallax and intensity.
Anaglyph
LR sequential
L R L R
0.5 sec.
0.5 sec.
Setting
Follow the steps below to select a monitoring method.
1
Press ADJUST MODE and select a setting value using
Monitoring method
Normal
Anaglyph
(ANAGLYPH MODE)
LR sequential
(LR-SEQ. MODE)
2
Adjust a setting value using
06
EN
Normal
Normal 3D images are output as they are. You can adjust images while
viewing them as natural 3D ones by using a 3D-compatible monitor.
Images for the left and right eyes are colored in red and blue respectively
and displayed on one screen in layers. You can check parallax adjustment by
viewing the gap between the left and right images even on a 2D (conventional)
monitor or without 3D glasses.
●
Be aware that it is difficult to see the colors and stereoscopic effect
correctly in anaglyphic representation.
Images for the left and right eyes are displayed alternately at 0.5-second
interval. You can view images in this method on a conventional 2D monitor
but it requires training to see them as 3D images.
0.5 sec.
0.5 sec.
Setting value
Content
PARALLAX
Parallax and intensity are adjusted using an image displayed in the format selected
INTENSITY
in 3D MIX FORMAT.
SUB INT.
PARALLAX ANA
INTENSITY ANA
Parallax and intensity are adjusted using an image displayed in anaglyph.
SUB INT. ANA
PARALLAX LRS
INTENSITY LRS
Parallax and intensity are adjusted using an image displayed in LR sequential.
SUB INT. LRS
. (0 - +60)
monitoring method
.
Advertisement
Table of Contents
