Functions For Camera Adjustment - JVC IF-2D3D1 Instructions Manual

Functions for camera adjustment –
This unit is equipped with a waveform monitor and vectorscope to check input signals from the 2 channels for
assisting with the adjustment of cameras and other devices. You can select one of three indication types and
four display positions for each scope.
Y
It displays the characteristics of input signals
on a waveform chart.
Select the scope and indication type you want.
Setting
Follow the steps below to select a monitoring method and its indication type.
1
Press SCOPE and select a scope using
Setting value
PARA._W.F.M.
PARA._V.S.
IN1_W.F.M.
IN1_V.S.
IN2_W.F.M.
IN2_V.S.
BAL._W.F.M.
BAL._V.S.
10
EN
Waveform monitor
(W.F.M.)
.
Indication type
Y Y
Y
Y
Waveform monitor and vectorscope
Vectorscope
(V.S.)
It displays the characteristics of input signals on a
vectorscope.
Content
Select this to display the waveform monitors/vectorscopes of
the images from the HD/SDI IN 1(L) and HD/SDI IN 2(R) terminals
side by side.
Adjust the settings of the cameras so as to make the forms of the
signals as similar as possible.
Select this to display the waveform monitor/vectorscope of the
image from the HD/SDI IN 1(L) terminal.
Select this to display the waveform monitor/vectorscope of the
image from the HD/SDI IN 2(R) terminal.
Select this to display the differential of the signals from the HD/
SDI IN 1(L) and HD/SDI IN 2(R) terminals in waveform monitor/
vectorscope.
No signal differential (flat line on the waveform monitor and
center dot on the vectorscope) is ideal. Adjust the settings of the
cameras so as to make the differential as small as possible.