Table of Contents
Advertisement
The three functions below are available as options of the scope function while it is activated.
Gain adjustment
You can adjust the gain of the waveform monitor/vectorscope.
1
Adjust the setting value using
Scope filter
Use it to activate a lowpass filter to limit the frequency band of the scope.
1
Press FUNCTION while using the scope function and select SCOPE FILTER using
2
Select LOWPASS using
Scope position
You can change the display position of waveform monitor/vectorscope.
1
Press FUNCTION while using the scope function and select SCOPE POSITION using
2
Select a position using
Functions for camera adjustment –
You can turn an input image upside-down. This is useful when you must
set a camera upside-down. The frames of the left and right images are
automatically synchronized when using this function.
OFF
One camera is set upside-
down.
Setting
1
Press FUNCTION and select ROTATE using
2
Select a setting value using
while displaying the waveform monitor or vectorscope. (-30 - 0 - +30)
.
.
LEFT UPPER
LEFT LOWER
SDI 1(L) ROTATE (inversion of the left image)
SDI 2(R) ROTATE (inversion of the right image)
The image from HD/SD SDI IN 1(L) or HD/SD SDI IN
2(R) is inverted.
●
.
.
.
.
RIGHT UPPER
RIGHT LOWER
Rotation
One-frame delay is required for image rotation.
The unit also delays the non-rotated image by
one frame in order to synchronize them.
Example camera setting
11
EN
Advertisement
Table of Contents
