Installation Requirements; Tools And Parts; Location Requirements - Jenn-Air Overlay BEVERAGE CENTER Use & Care Manual

Tools and Parts

Gather the required tools and parts before starting installation.
TOOLS NEEDED:
Phillips screwdriver
PARTS NEEDED:
Custom Overlay Frame—See "Overlay Frame—Rear View."
Hardware (Optional)
PARTS SUPPLIED:
M4 x 14 wood screws (12)

Location Requirements

WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from beverage center.
Failure to do so can result in death, explosion, or fire.
NOTES:
For the beverage center to be flush with the front of the base
cabinets remove any baseboards or moldings from the rear of
the opening. See "Product Dimensions" and later in this
section "Opening Dimensions."
It is recommended that you do not install the beverage center
near an oven, radiator, or other heat source.
Do not install in a location where the temperature will fall
below 55°F (13°C). For best performance, do not install the
beverage center behind a cabinet door or block the base
grille.
4

INSTALLATION REQUIREMENTS

Opening Dimensions
Height dimensions are shown with the leveling legs extended
to the minimum height.
NOTE: When leveling legs are fully extended, add
(15.9 mm) to the height dimensions. See "Product
Dimensions."
If the floor of the opening is not level with the kitchen floor,
shim the opening to make it level with the kitchen floor.
14 "
(37.5 cm)
A
"
(1.3 cm)
24"
(60.96 cm)
min.
24" (60.96 cm) min.
Critical Dimensions:
A. 14 " (37.5 cm) utility opening
B. 24" (60.96 cm) minimum opening width
"
34 " (87.3 cm) min.
35" (88.9 cm) max.
B