Beverage Center Installation; Location Requirements - Jenn-Air JUBFR242HM Use And Care Manual And Installation Instructions

Under counter beverage center
Table of Contents

Advertisement

Available languages

Available languages

13.
Hushed Acoustics
Our internal compressor keeps your beverages
impeccably chilled, while running unobtrusively in
the background. Brilliance doesn't have to announce
itself; it just is.

BEVERAGE CENTER INSTALLATION

LOCATION REQUIREMENTS

WARNING
Explosion Hazard
Keep flammable materials and vapors,
such as gasoline, away from beverage center.
Failure to do so can result in death, explosion, or fire.
IMPORTANT: This appliances is intended to be used in
household and similar applications such as:
 Staff kitchen areas in shops, office and other working
environments;
 Farm houses and by clients in hotels, motels and
other residential type environments;
 Bed and breakfast type environments;
 Catering and similar non-retail applications.
NOTES:
 For the beverage center to be flush with the front
of the base cabinets, remove any baseboards or
moldings from the rear of the opening. See "Product
Dimensions" and later in this section, "Opening
Dimensions."
 It is recommended that you do not install the
beverage center near an oven, radiator, or other heat
source.
 Do not install in a location where the temperature will
fall below 55°F (13°C). For best performance, do not
install the beverage center behind a cabinet door or
block the base grille.
OPENING DIMENSIONS
 Height dimensions are shown with the leveling legs
extended to the minimum height.
NOTE: When leveling legs are fully extended, add
5/8" (15 mm) to the height dimensions. See "Product
Dimensions."
 If the floor of the opening is not level with the kitchen
floor, shim the opening to make it level with the
kitchen floor.
14.
Emotive Controls
Hold sway over every zone. Let your light-guided
touch coax out the flavors of beverages, spirits and
beyond.
C
B
Opening and utility location dimensions
Opening width - A
Opening depth - B
Opening height - C
Dimension - D
Dimension - E
Dimension - F
Dimension - G
Dimension - H
Dimension - I
For flush installation, the power outlet can be installed in
adjacent cabinetry with a cutout on the power cord side
for routing of the power cord.
The power outlet can also be recessed on the back
wall behind the unit as per recommended receptacle
locations in the above illustration.
G
I
F
G
E
H
F
D
A
24" (60.96 cm) min.
24" (60.96 cm) min.
341/2" (87.6 cm) min.
35" (88.9 cm) max.
121/16" (30.64 cm)
213/4" (55.16 cm)
13/4" (4.44 cm)
3" (7.55 cm)
41/2" (11.37 cm)
91/4" (23.47 cm)
Recessed
receptacle
locations
Utility
opening
5

Advertisement

Table of Contents
loading

Table of Contents