Assembly - NordicTrack NTL19010.3 User Manual

ASSEMBLY

• Assembly requires two persons.
• P lace all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• T he underside of the walking belt is coated with
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
1. Make sure that the power cord is unplugged.
Identify the right Upright (77), which has a wire
tie in it. Hold the Upright near the right side of
the incline trainer.
See the inset drawing. Tie the wire tie in the
right Upright (77) around the end of the Upright
Wire (78). Then, pull the other end of the wire tie
until the Upright Wire is routed out of the top of
the Upright.
• To identify small parts, see page 6.
• A ssembly requires the following tools:
the included hex keys
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
Wire
Tie
78
77
7
Wire
Tie
77
78