Hitachi L37X01AU User Manual page 18

CONNECTION (continued)
Connecting Procedure (continued)
1. Connecting Power Cord to Rear Panel.
Connect power cord to the television.
* Make sure not to connect the power plug to the wall socket
until all connections are completed.
2. Connecting Aerial Lead.
There are two ways to connect aerial lead.
When you do not have any other external equipment
Connect the aerial lead directly into the socket at rear
panel.
When you have one or more external devices to
connect:
1. Use RF cable to connect between each equipment and
aerial.
2. Connect the Aerial Lead to an equipment "In" socket
marked
3. Connect the RF cable from the equipment "Out" to the
other equipment "In".
4. Then, connect from the equipment "Out" to "ANT" on the
LCD screen socket.
Precautions when connecting the aerial
Please use a coaxial cable which is free from interference to connect the aerial. Avoid using a parallel flat feeder
wire as interference may occur, causing reception to be unstable and stripe noise to appear on the screen.
Avoid using indoor aerial as this may be affected by interference. Please use CATV net or outdoor aerial.
For safety, install an external aerial conforming to AS1417.1( Applicable for Australia only)
If there are noise in the picture of VHF-Low band channel, please use the double-shielded cable (not provided) for
RF LEADS to reduce the noise.
STB
[Example: Connecting Antenna through STB
and VCR.]
VCR
16