Remote Control; Loading Batteries; Handling The Remote Control - Hitachi 42PD5000 User Manual

01 QR58553-英語-初校 03.10.15 10:47 AM ページ9

Remote control

POWER OFF button
POWER ON button
RGB/VIDEO buttons

Loading Batteries

1. Open the battery cover.
• Slide back and remove the battery
cover in the direction of the arrow.
2. Load batteries.
• Load two Size AA batteries included observing the correct
polarities.
3. Close the battery cover.
• Replace the battery cover in the direction of the arrow and snap
it back into place.
CAUTION
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as
marked on the product. If loaded in the wrong direction, the
batteries could explode or leak, resulting in fires, physical injury,
or stains.
13
13
MUTE button
14
14
RGB 1
PinP button
34
AV1
AUTO button
16
AUTO
MENU
MENU button
16
OK button
16
ID
ID button
16
13
POWER ON/OFF button
14
VOLUME UP/DOWN buttons
VOL
RGB 2 MUTE VOL
15
SIZE button
AV2 AV3 AV4
15
RECALL button
PinP SIZE RECALL
16
RETURN button
OK
16
SELECT/ADJUST buttons
ID SET
16 ID SET button

Handling the Remote Control

Use the remote control within about 5 m from front of the unit's
remote-control sensor and within 30 degrees on both sides.
With in 30
degrees
About 3m
ATTENTION
• Do not drop or impact the remote control.
• Do not splash the remote control with water or put it on a wet
object to avoid possible failures.
• Before leaving the remote control out of use for an extended
period of time, remove the batteries from it.
• If the remote control begins to lack responsiveness, replace the
batteries.
• Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational
failure. Position this unit to avoid direct contact with such light.
With in 30
degrees
About 3m
About 5m
VOL
RGB 1 RGB 2 MUTE VOL
AV1 AV2 AV3 AV4
AUTO PinP SIZE RECALL
MENU
OK
ID ID SET
9