Size Switching; Input Signal Screen Display - Hitachi 42PD5000 User Manual

01 QR58553-英語-初校 03.10.15 10:47 AM ページ15

Size Switching

Each time the SIZE button of the remote control or the monitor is pressed, the screen display area will change in
sequence and the status will be displayed at the bottom of the screen.
* Real mode gives the image of the same shape as it is displayed on a computer monitor.
This mode is only available for VGA (640 X 480) and WVGA (864 X 480).
Display area selection diagram (RGB input)
Resolution Full display
Display
640 X 480
(VGA)
800 X 600
(SVGA)
1024 X 768
(XGA)
1280 X 1024
(SXGA)
1600 X 1200
(UXGA)
Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that
flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On
the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.
･ The display will go out in approximately 6 seconds.
RECALL button
SIZE button
Normal
*
Real
Full Normal
RGB
Off-timer
-- -- Min.
OFF
On-timer
-- -- : -- --
RGB 1
AV1
AUTO
MENU
SIZE button
ID
Full Zoom1
Zoom3 Zoom2
Circular display
Real Zoom1
* VGA and W-VGA
only
Input mode
RGB2
RGB
Signal mode
H : 48.4kHz
Input horizontal frequency
V : 60.1 Hz
Input vertical frequency
RGB 2 MUTE VOL
AV2 AV3 AV4
PinP SIZE RECALL
RECALL button
OK
ID SET
Zoom2 Zoom3
can reduce
20
15